We combine the exposure of Classified Listings with the excitement of Online Farm Equipment Auctions. All for one transparent Flat Fee.
No surprise fees. No commissions. No kidding!
I’m selling my Peck 10inch by sixty six, foot grain auger, 540 PTO, this auger has all new bolts in the flighting sections, good flighting, new bearings, we upgraded to a low profile dual auger hopper with rubber tires. This auger is ready to go for harvest. The auger tires are around 30 percent tread.
I have a like new Vermeer 504r signature baler. It’s been a great machine with no problems. Has an atlas bale monitor. It is a net only machine. It has only 1675 bales. I’m the only owner of this machine. It has been barn kept when not in use. It went through the shop last winter just for general maintenance and tuning. Comes with a roll and a half of Vermeer net. It’s ready for its new owner. Only getting rid of because I’m getting out of the haying business.
2012 Case Ih 1240
-12-30”
-A little over 10k acres
-AgLeader Electric Row clutches on every row
-Hydraulic Drive
-Yetter Floating row cleaners
-Corn and Bean plates.
-Stand alone harness for a pro 700 for fold functions.
-Ag leader tractor side harnesses required to run Ag leader monitor.
*New last season
(Seed boots, Frogs, Closing arm bushings, Closing discs, Gauge wheel pins, new wing tires, 48 cell corn plates, Had meters ran, Fan hydro lines, Bull pull Hitch).
Going to a 16 row. Ready to plant!
Selling this G5 Display. Bought it a couple years ago as a spare and haven’t needed it. It does NOT have any active activations. If you want to autotrac or section control you will need to buy a yearly subscription for it.
Power plug in harness is Not included. It didn’t come with one when I bought it for some reason.
Features a 12.8-inch touchscreen with 1080p high-definition resolution
Built with a processor that is three times faster than previous models for quicker cold boot times and smoother navigation
Selling our 1998 664 New Holland Baler. We used this for a few years as our second baler. When we bought it the first owner had just put all new roller bearings in it and said it had 3400 bales on it. The bale command plus display says 2000 something bales but that is not correct. We put around 200-300 bale on the baler since we bought it. So it is a fairly low bale count baler. We have been running nylon twine, it wraps well and gave us no issues this year putting up ditch hay.
It runs off of a 540 PTO, has one hydraulic line for the baler pickup and requires one set of SCV’s for the chamber door. Makes 5×6 bales. Always shedded on our farm, greased and maintained. Paint looks good, a couple normal wear spots, paint chips, and minor dents. Comes with the command baler plus interface and has one like new rim and tire.
1983 John Deere 4050 2WD, Sound-Gard Cab, 6,050 Hrs, 466 Diesel. We used it for haying and odd jobs around the farm. Like new front tires, recently replaced the water pump. AC blows cold and heat. 2 SCVs 540/1000PTO. Also has 3 point, everything is functional as it should be. A nice opportunity to purchase an early 50 Series 4050 Sound guard Cab with the desirable 466 diesel and Quad-Range transmission. Just had a fresh oil change. Power steering of course. Rear tires are getting towards the end of their life. Comes with a piece of plexi glass covering the back window. We installed that to protect the back window from rocks hitting it while baling hay. Has Block Heater as Well
I am selling my 2017 Case CX26C Mini Excavator. It has enclosed cab, 827 hours, and has been used seldom the last 3 years. Pins seem tight, paint job looks good with some minor dings and scratches. Tracks have a lot of life yet and the engine starts right away and runs well. I have had no issues with it. Reason for selling is we don’t use it much. Has a Kubota engine weighs around 5500lbs. Comes with 2 buckets, a 12inch and an 18inch. Also comes with a quick attach coupler, as seen in the photos. All around clean machine, with a lot of life left for someone that will use it more than me.
Has Auxiliary hydraulic hookups for a thumb if someone wanted to add a thumb.
WATCH THE VIDEO BELOW….. Cole will be listing some items, but YOU can start LISTING YOUR STUFF NOW! Take advantage of the viewers that Cole and the Sonne Farms YouTube channel brought over. You can be sure someone is looking to buy something YOU have!! It’s FREE to list your item for Auction. There are NO COMMISSIONS for Buyers or Sellers. Only the Winning Bidder of a successful auction pays a $249 auction fee. That’s it!
This weekend was the Test Launch of our FlatFeeFarmEquipmentAuction.com site AND our FlatFeeCarAndTruckAuction.com site with Derek putting up some of his Vice Grip Garage project cars. If you are thinking of selling or buying, I can assure you there are a lot of eyes watching these two sites now and there will be some explosive growth this year with some major upcoming developments. So, get those Farm Items you no longer need out of your way and into the barn of someone that wants them!
Thanks for joining us! — Wayne Parks Founder, FlatFeeAuctionWorld.com
